All critical components (cam packs, spool valves, etc.) are triple-tested to ensure product reliability. All electronic components functionally tested and replaced, where needed Every pump is computer-tested to measure pressure, bypass, fluid flow, valve operation, steering effort and noise. Brush assembly tolerance specs validated or replaced with new components, if necessary Units are supplied with 100% tested and calibrated pressure relief valves. Additional Info: CARDONE Remanufactured Power Steering Pumps are engineered to meet or exceed O.E. performance. Original designs are scrutinized for potential improvement and, where applicable, design upgrades are implemented to produce a more durable part than the original. All critical components are tested to ensure proper function. Every unit undergoes a hydraulic efficiency test to ensure reliable, long-lasting performance. 1. Package Dimensions: 10.750 x 7.125 x 6.500 inches 2. UPC: 082617331449 3. E-Waste: No 4. Hose Port Type: O-Ring 5. Housing Material: Cast Iron 6. Mounting Hardware Included: No 7. Package Contents: Pump, O-Ring (2), Reservoir, Instruction Sheet 8. Power Steering Outlet Thread Size: M16 x 1.5 9. Power Steering Pump Inlet Attachement Type: Hose Barb 10. Power Steering Pump Outlet Attachment Type: Threaded 11. Power Steering Pump Outlet Quantity: 1 12. Power Steering Reservoir Cap Included: No 13. Product Condition: Remanufactured 14. Product Line Marketing Stmt: CARDONE Industries, Inc. is the remanufactured parts supplier to the O.E.Ms. We are the only remanufacturer in the world with over 45 years' experience in mechanical, hydraulic and electronic parts repair. Through reverse-engineering, our product engineers are able to determine where - and why - original parts fail. We re-engineer our A1 CARDONE(R) Reman parts for stronger, longer-lasting performance. We build it better. Learn more at Cardone.com. 15. Pulley Attachement Type: Press-On 16. Pulley Included: Not Required 17. Remote Reservoir: Yes 18. Reservoir Included: Yes 19. Country of Origin: MX 20. Remanufactured Part: Y Q: Why is the pump making a whining noise all of the time? A: A whining pump is usually caused by air in the power steering system. Inspect the reservoir for proper fluid level. If fluid has foam or air bubbles present, air has entered the system or has not been properly bled (ensure all hoses/clamps are tight). Some systems require special vacuum bleeding procedures. ***************************************** Q: Why do I still have hard steering in one direction after I replaced the pump? A: The problem is most likely in the steering unit-the pump does not know left from right. Check for binding steering components and repair as necessary. ***************************************** Q: I bought a replacement power steering pump and my original pulley has a loose fit on the replacement pump shaft. What should I do? A: The end of the original pump's input shaft enlarged causing the pulley hole to increase during removal. The pulley must be replaced. ***************************************** Q: I only have assist when increasing engine rpm after installing the replacement pump. What's causing this? A: There may be debris in the flow control valve bore not allowing the flow control valve to move as it should. (Valve and bore are located behind the high pressure fitting on the pump). The system must be checked for contamination and flushed. ***************************************** Q: Should I ever change my fluid, even though nothing is wrong? A: Yes. Some O.E. manufacturers recommend that power steering fluid be changed at 50,000 miles and continue at that interval. Just like engine oil, power steering fluid will eventually break down and carry suspended contaminants from component wear and breakdown. Follow your vehicle's O.E. manufacturer's recommendations on fluid change intervals.