Direct fit replacement All units are built with 100% new O-rings and premium-grade HNBR seals to prevent leaks. HNBR does not break down at high temperatures like conventional seal material. Every pump is computer-tested to measure pressure, bypass, fluid flow, valve operation, steering effort and noise. Brush assembly tolerance specs validated or replaced with new components, if necessary 100% tested using CARDONE Road Simulation Technology Additional Info: Electronic Hydraulic Power Steering Pumps provide better engine efficiency and performance over traditional power steering pumps. Rather than increasing the load on the engine to run the hydraulic system, the electric motor on EHPS units provides power to the system. By eliminating additional strain on the engine, EHPS units help to increase fuel efficiency and reduce CO2 emissions. CARDONE remanufactured Electronic Hydraulic Power Steering Pumps are a cost-effective, high-quality alternative to expensive O.E. replacement units. 1. Package Dimensions: 10.750 x 7.125 x 6.500 inches 2. UPC: 082617024754 3. E-Waste: No 4. Hose Port Type: O-Ring 5. Housing Material: Cast Iron 6. Mounting Hardware Included: No 7. Package Contents: Pump, O-Ring (2), Reservoir, Instruction Sheet 8. Power Steering Outlet Thread Size: M16 x 1.5 9. Power Steering Pump Inlet Attachement Type: Hose Barb 10. Power Steering Pump Outlet Attachment Type: Threaded 11. Power Steering Pump Outlet Quantity: 1 12. Power Steering Reservoir Cap Included: No 13. Product Condition: Remanufactured 14. Product Line Marketing Stmt: CARDONE Industries, Inc. is the remanufactured parts supplier to the O.E.Ms. We are the only remanufacturer in the world with over 45 years' experience in mechanical, hydraulic and electronic parts repair. Through reverse-engineering, our product engineers are able to determine where - and why - original parts fail. We re-engineer our A1 CARDONE(R) Reman parts for stronger, longer-lasting performance. We build it better. Learn more at Cardone.com. 15. Pulley Attachement Type: Press-On 16. Pulley Included: No 17. Remote Reservoir: Yes 18. Reservoir Included: Yes 19. Country of Origin: MX 20. Remanufactured Part: Y Q: Why is the pump making a whining noise all of the time? A: A whining pump is usually caused by air in the system. Remove reservoir lid and inspect fluid level and condition. If fluid has foam or air bubbles present, you must bleed the system again. Some systems are very difficult to bleed manually and may require the use of a vacuum pump to extract all of the air from the system. ***************************************** Q: Why do I still have hard steering in one direction after I replaced the pump? A: The problem is not in the pump, it is in the steering gear. The pump would cause a steering problem in both directions. ***************************************** Q: I bought a replacement power steering pump and my original pulley has a loose fit on the replacement pump shaft. What should I do? A: The end of the original pump's input shaft enlarged causing the pulley hole to increase during removal. The pulley must be replaced. ***************************************** Q: I only have assist when increasing engine rpm after installing the replacement pump. What's causing this? A: There may be debris in the flow control valve bore not allowing the flow control valve to move as it should. (Valve and bore are located behind the high pressure fitting on the pump). The system must be checked for contamination and flushed. ***************************************** Q: Should I ever change my fluid, even though nothing is wrong? A: Yes. Some O.E. manufacturers recommend that power steering fluid be changed at 50,000 miles and continue at that interval. Just like engine oil, power steering fluid will eventually break down and carry suspended contaminants from component wear and breakdown. Follow your vehicle's O.E. manufacturer's recommendations on fluid change intervals.